Creating Bar Code Fields - Paxar Monarch 6015 Programmer's Manual

C r e a t i n g B a r C o d e F i e l d s
The printer can print the following bar codes, with or without human-
readable data.
Code 39
Codabar
Interleaved 2 of 5
Code 128 (UCC/EAN-128)
UPC/EAN/JAN
Command
ESC-'z'-<bctype>-
<length>-<height>-
<data>
ESC-'Z'-<bctype>-
<length>-<height>-
<data>
<bctype>
<length>
<height>
<data>
6
Description
Prints a bar code without human-readable
data.
Prints a bar code with human-readable data.
The type of bar code to print (values are the
ASCII representation, not hex).
'1' Code 39
'2' Code 128 (UCC/EAN-128)
'3' Interleaved 2 of 5
'4' UPC/EAN/JAN
'5' Codabar
The length of the bar code data (in hex). This
value is dependent on the bar code you
choose with <bctype> (see below).
The height of the bar code (in hex) in
increments of .125 mm. <height> can be no
smaller than 14. For example, 14 = 2.5 mm,
15 = 2.625 mm, etc.
For UPC/EAN/JAN bar codes, the height you
specify will include a 1.25 mm drop bar
pattern after the bar code.
The data for the bar code. Its length must
equal <length> . See the following table for
data restrictions, which vary by bar code.