Mitsubishi FX3G Series Programming Manual page 45

FX /FX /FX /FX
3G 3U 3GC 3UC
Programming Manual - Basic & Applied Instruction Edition
Classification
PLC system
setting (2)
[Serial
communication]
Positioning
setting
Special
*6
parameters
Others
*1. This function is supported only in FX
*2. This item is supported only in the FX
*3. This function is supported only in FX
*4. The second entry code is supported in all FX
*5. The customer keyword and permanent PLC lock is supported in all FX
Ver. 2.61 or later.
*6. This function is supported in FX
*7. For FX /FX
3U
For FX /FX
3G
Series
Item
This parameter corresponds to the following settings by specifying the contents of each on the
Serial port PC screen:
operation Setting of communication format (D8120, D8400 and D8420)
setting Setting of station number (D8121 and D8421)
Setting of timeout check (D8129, D8409 and D8429)
This parameter sets interrupt inputs for the maximum speed, bias speed, creep speed, zero
Constant
return speed, acceleration time, deceleration time, and the DVIT instruction.
setting
It is necessary to set the memory capacity.
This parameter sets the operation table.
Detailed setting
It is necessary to set the memory capacity.
Network
Special parameters are used in special adapters, special function blocks, etc.
*7
They are stored in the main unit.
parameter
This parameter sets protection to prevent erroneous read/incorrect write protection of a sequence
program. The entry code (8 characters), 2nd entry code (8 characters)*
Keyword
keyword (16 characters)
In addition, a permanent PLC lock
This parameter enables a character string to be set as the program title.
Program title
/FX
3U
3UC
/FX
3G
/FX
3G 3GC
PLCs, this function is supported in GX Works2 Ver. 1.73B or later.
3UC
PLCs, this function is supported in GX Works2 Ver. 1.87R or later.
3GC
Description
*5
can each be specified in characters in the ranges of A to F and 0 to 9.
*5
can be specified.
PLCs.
3UC
-32MT-LT-2.
PLCs.
3GC
/FX PLCs and FX
3G 3GC 3U
PLCs Ver. 2.00 or later and FX
2 Overview (Sequence Program)
2.7 Types and Setting of Parameters
*1
4
and the customer
/FX PLCs Ver. 2.20 or later.
3UC
/FX PLCs and FX /FX
3G 3GC 3U
/FX PLCs Ver. 3.10 or later.
3U 3UC
1
2
3
4
PLCs
3UC
5
6
7
8
9
10
43