Mitsubishi FX3G Series Programming Manual page 382

FX /FX /FX /FX
3G 3U 3GC 3UC
Programming Manual - Basic & Applied Instruction Edition
5. Others
1) Types of pulse output, positioning and other relevant instructions and their target output numbers
Classification
Pulse output
Positioning
High-speed
processing
*1. Y002 (pulse output destination) cannot be specified for the FX
PLC.
*2. The pulse output destination Y003 can be specified only when two special high-speed output adapters are
connected to an FX
*3. This function is supported only in FX
2) When using the same output relay (Y000 or Y001) in several instructions.
While a pulse output monitor (BUSY/READY) flag is ON, a pulse output or positioning instruction for the same
output relay cannot be executed.
While a pulse output monitor flag is ON, even after the instruction drive contact is set to OFF, a pulse output or
positioning instruction for the same output relay cannot be executed.
Before executing a pulse output or positioning instruction, wait until the pulse output monitor flag turns OFF and
one or more operation cycles pass.
Pulse output destination device
380
Series
Instruction
PLSY(FNC 57)
PLSR(FNC 59)
DSZR(FNC150)
*3
DVIT(FNC151)
ZRN(FNC156)
PLSV(FNC157)
DRVI(FNC158)
DRVA(FNC159)
PWM(FNC 58)
PLC.
3U
/FX
3U
Pulse output monitor flag
Y000
Y001
13 High-Speed Processing – FNC 50 to FNC 59
13.10 FNC 59 – PLSR / Acceleration/Deceleration Setup
Instruction name
Pulse Y output
Acceleration/deceleration setup
DOG search zero return
Interrupt positioning
Zero return
Variable speed pulse output
Drive to increment
Drive to absolute
Pulse width modulation
PLC (14-point and 24-point type) and FX
3G
PLCs.
3UC
M8340
M8350
Target output numbers
Y000,Y001
Y000,Y001
*1 *2
Y000,Y001,Y002 ,Y003
*2
Y000,Y001,Y002,Y003
*1 *2
Y000,Y001,Y002 ,Y003
*1 *2
Y000,Y001,Y002 ,Y003
*1 *2
Y000,Y001,Y002 ,Y003
*1 *2
Y000,Y001,Y002 ,Y003
*1 *2
Y000,Y001,Y002 ,Y003
3GC