Removing And Installing The Door Panels - Bosch HGV745363Q Instruction Manual

Attaching the door
Reattach the oven door in the reverse sequence to removal.
1. When attaching the oven door, ensure that both hinges are
inserted straight into the opening (figure A).
2. The notch on the hinge must engage on both sides (figure B).
$
3. Fold back both locking levers (figure C). Close the oven door.
&
:
Risk of injury!
If the oven door falls out accidentally or a hinge snaps shut, do not
reach into the hinge. Call the after­sales service.

Removing and installing the door panels

To facilitate cleaning, you can remove the glass panels from the
oven door.
Removal
1. Detach the oven door and lay it on a cloth with the handle facing
down.
2. Pull off the cover at the top of the oven door. Press in the tabs
on the left and right using your fingers (fig. A).
3. Lift the top panel up and pull it out (fig. B).
$
4. Lift the panel up and pull it out (fig. C).
&
78
%
%
Clean the panels with glass cleaner and a soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a crack.
Do not use a glass scraper, sharp or abrasive cleaning aids or
detergents.
Installation
During installation, make sure that the lettering "top right" is
upside down at the bottom left.
1. Insert the panel at an angle towards the back (fig. A).
2. Insert the top panel at an angle towards the back into the
brackets. The smooth surface must face outwards. (fig. B).
$
3. Put the cover back in place and press on it.
4. Attach the oven door.
Do not use the oven again until the panels have been correctly
installed.
%