Storing The Allegro 2 And Battery Pack; Protecting The Touchscreen - Juniper Allegro 2 Owner's Manual

Storage, Maintenance, and Recycling
Follow the instructions in this chapter to properly maintain
and recycle the Allegro 2.

Storing the Allegro 2 and Battery Pack

When the handheld is not being charged and is suspended,
it draws a small amount of power. This power draw is used to
maintain the memory (RAM) of the handheld in the same state
it was when it was suspended. We recommend charging the
handheld each night or weekend when it is in suspend mode.
If the Allegro 2 is not charged while in suspend mode and the
battery reaches a low charge, it automatically powers off to
prevent further drain on the battery.
Note: Data and programs are secure as long as they have
been saved, even if the battery pack becomes discharged.
The handheld does not depend on the battery to store the
data for extended periods.
Storing the Allegro 2 for Less Than Two Weeks
To store the handheld for less than two weeks, complete the
following steps:
1. Close all applications.
2. Plug the handheld into the AC wall adapter that was
shipped with your unit.
Storing the Allegro 2 for More than Two Weeks
To store the handheld for two weeks or more, complete the
following steps:
1. Charge the battery pack 30 to 50 percent.
2. Close all running programs, and turn off the handheld.
3. Remove the battery pack.
4. Place the battery pack in a dry location.

Protecting the Touchscreen

Protect the touchscreen from impact, pressure, or abrasive
substances that could damage it. To further protect the
touchscreen, apply a screen protector (optional accessory).
102
Allegro 2 Rugged Handheld Owner's Manual