Juniper Allegro 2 Owner's Manual page 101

3. My TLC-39 Composite barcode will not scan.
Reason/Solution: On the 1D Code Types screen ensure that
Code 39 is checked. Also select Options, then the Code
39 screen and ensure that Convert Code 39 to Code 32 is
unchecked.
4. My UPC barcode will not scan.
Reason/Solution: On the 1D Code Types screen ensure that
barcode types UPC-A, UPC-E and UPC-E1 are checked.
If composites codes are also enabled on the Composite/
Postal Code Types screen and you still want to allow a UPC
1D to scan, select Autodiscriminate from the drop down
list. Also go to the 1D Code Types screen, select Options,
then the tabs for UPC/EAN-1 and UPC/EAN-2. Make sure the
settings are correct for your application.
5. My Code 39 Full ASCII barcode will not scan.
Reason/Solution: On the 1D Code Type screen, select
Options, then the Code 39 screen. Ensure that the lengths
are set to the fullest range.
6. My Bookland EAN barcode will not scan.
Reason/Solution: Ensure that both Bookland EAN and EAN-
13 are enabled on the 1D Code Types screen.
7. My ISBN, ISMN, ISSN, or JAN barcodes will not scan.
Reason/Solution: These barcode types are all subsets of
EAN-13. Ensure that EAN-13 is enabled on the 1D Code Types
screen.
8. I can't figure out how to configure Intelligent Mail or
OneMail barcodes.
Reason/Solution: Intelligent Mail and OneMail barcodes are
the same thing. They are also called USPS 4CB (located on
the Composite/Postal Code Types screen).
9. CLSI editing has no effect.
Reason/Solution: CLSI editing is only supported for 14
character Codabar barcodes.
Chapter 9 Barcode Scanner
97