Juniper Allegro 2 Owner's Manual page 63

Note: When you suspend the Allegro 2, the receiver is
in a low power mode to retain its almanac. When you
resume, it takes a few seconds to get a fix.
GPS/GNSS Accuracy
The GPS/GNSS antenna is in the top of the Allegro 2. Do not
put your hand or another object over the top bumper or
display. This reduces accuracy. The more items between you
and the satellites, the lower the accuracy.
GPS/GNSS Settings
To view or make changes to the GPS/GNSS settings or set up
an external GPS/GNSS receiver, press and hold the GPS/GNSS
status gadget on the Home screen to open the GNSS control
panel.
Scroll through the menu and set up the desired parameters.
Select from pull-down lists and enable or disable
checkboxes and circles by selecting or deselecting them.
Programs: Select the program port (COM2 is the default).
„
Several applications can share the COM port setup as
the GPS/GNSS program port using the GPS Intermediate
Driver (GPSID). See the section on the GPS Intermediate
Driver later in this chapter for details.
Hardware: Specify the hardware port your GNSS device
„
is connected to (COM8 is the default) and the baud rate
(internal GNSS uses 115200 baud)
Access: Multiple programs can obtain GPS data
„
Chapter 6 GPS/GNSS
59