Juniper Allegro 2 Owner's Manual page 85

compartment. Loosen the screws to the door and
remove it.
!
CAUTION: Do not use a micro SIM adapter. The adapter can
get stuck and damage the slot.
3. Remove the battery pack.
!
CAUTION: The Allegro 2 is not sealed against water and dust
when the battery door is not installed.
4. An image on the battery compartment label shows the
correct location and orientation for the mini SIM card.
Pull out the SIM card tray. Place the card onto the tray
and push the tray in until it catches.
To remove the SIM card, pull the tray open and remove the
card. Push the empty tray in until it catches.
5. Replace the battery pack, and attach the battery door.
6. Power on the Allegro 2.
Note: If the modem was on before shutting the Allegro 2
down to insert the SIM card, you are prompted to configure
the data connection when you reboot. See the instructions
on the following pages.
Chapter 8 3G Data Modem
81