Storing The Allegro 3 And Battery Pack; Cleaning The Allegro 3 - Juniper Allegro 3 Series Owner's Manual

Storage, Maintenance, and Recycling
Follow the instructions in this chapter to properly maintain
and recycle the Allegro 3.

Storing the Allegro 3 and Battery Pack

Storing the Allegro 3 for More than Two Weeks
To store the handheld for two weeks or more, complete the
following steps:
1. Charge the battery pack 30 to 50 percent.
2. Close all running programs, and turn off the handheld.
!
CAUTION: Always perform Power Off before removing
battery. Failure to do so may cause loss of data or
damage to handheld.
3. Remove the battery pack.
4. Place the battery pack in a dry location.

Cleaning the Allegro 3

Touchscreen
Suspend the Allegro 3. Apply warm water or a mild cleaning
solution to a micro fiber cloth and gently wipe off the
touchscreen.
!
CAUTION: Do not use soft bristle brushes or harsh cleaning
solutions on the touchscreen.
Rinse the touchscreen with water and dry it with a micro
fiber cloth.
Case, Bumpers, and Connector Module
Make sure the battery door is securely installed. Use warm
water, a mild cleaning solution, and a soft bristle brush to
clean the case, bumpers, and connector module.
!
CAUTION: Do not direct a high-pressure stream of water
at the device to clean it. This action could break the seal,
causing water to get inside the device and voiding the
warranty.
20
Allegro 3 Rugged Handheld Powered by Android Owner's Manual