Subdued Lighting (Tactical) Mode - Juniper Allegro 2 Owner's Manual

Restoring the Allegro 2 to its Factory State (Clean Boot)
Follow the steps below to restore user storage, settings, and
icons on your Allegro 2 to their original factory defaults.
!
CAUTION: Restoring the Allegro 2 to its original factory state
permanently erases data saved on the handheld, any
software you installed, and any changes you made to the
handheld, including changes to settings.
1. Back up files and programs you want to keep onto
another computer.
2. Save open files and close running programs on the
handheld. Press and hold the power key
Power Key menu appears. Tap Reset.
3. When the screen turns black, press and hold the
power key
4. Move the top slider on the screen to the right to set or
clear factory defaults (this clean boots the handheld).
5. Tap Exit. The boot process continues. The Update Time
screen is shown. Update the information as needed and
press OK.

Subdued Lighting (Tactical) Mode

In some environments subdued lighting is preferred. The
display backlight, LEDs, and keyboard illumination can be
subdued during the startup process and normal operation.
Set Up During a Reset
1. Save open files and close running programs on the
Allegro 2. Press and hold the power key
Power Key menu appears. Tap Reset.
2. When the screen turns black, press and hold the
power key
3. Move the slider on the screen to the right to turn the
tactical mode on.
4. Tap Exit. The boot process continues.
To restore the handheld to default lighting, follow the same
steps outlined above.
again until the bios screen is shown.
again. The bios screen is shown.
Chapter 3 Programs and Settings
until the
until the
41