Paper Jam Messages - Lexmark MX71x Service Manual

3
Close the rear door.
4
To clear the message and continue printing, select Next >

202 paper jam messages

Error code Description
202.01 Media remains on the sensor (narrow media)
during the warm‑up sequence (MS71x).
202.01 Media remains on the sensor (fuser exit)
during the warm‑up sequence.
202.03 The media is late reaching the sensor (fuser
exit) within the specified time.
202.05 The media reached the sensor (fuser exit) but
did not clear it within the specified time.
202.07 The media reached the sensor (fuser exit) but
did not clear it within the specified time.
202.13 The media is late reaching the sensor (fuser
exit) within the specified time.
202.14 Expected banner sheet (assumed wide) not
detected by narrow media sensor—possible
accordion jam, unsupported narrow banner
media, or missing signal.
202.16 Page at fuser nip before fuser started
ramping toward desired area. Indicates code
may be receiving more hall interrupts than
intended.
202.17 Page at fuser nip before fuser reached
acceptable operating temperature. Page
arrived at fuser earlier than expected, so it
was probably staged.
> Clear the jam, press OK >
Action
Go to "Sensor (narrow media) static jam service check" on
page 99.
Go to "Sensor (fuser exit) static jam service check" on page
95.
Go to "Sensor (fuser exit) late-arriving jam service check" on
page 97.
Go to "Sensor (fuser exit) late-leaving jam service check" on
page 96.
Go to "Sensor (fuser exit) late-leaving jam service check" on
page 96.
Go to "Sensor (fuser exit) late-arriving jam service check" on
page 97.
Go to "Sensor (narrow media) late arriving jam service check"
on page 98.
Go to "Fuser drive motor control jam service check" on page
91.
Go to "Fuser drive motor control jam service check" on page
91.
Diagnostic information
94
7463
.