–
Option tray symptoms
–
Sensor (mailbox pass through) jam service check
–
Mailbox diverter jam service check
–
Sensor (finisher pass through) jam service check
–
Finisher left tamper jam service check
–
Finisher right tamper jam service check
–
Finisher ejector jam service check
–
Finisher diverter jam service check
–
Finisher paddle jam service check
–
Finisher tray holder jam service check
–
Mailbox incorrect bin exit service check
–
Finisher door undetected service check
–
Stapler carriage failure service check
–
Finisher bin media present error service check
–
Output options
•
Added Bin insert (40X8855) to Parts catalog Assembly 1 and 2.
May 15, 2013
•
Updated the Transfer roll removal procedure.
•
Updated the ADF elevator tray motor stalled error service check.
•
Added installation note to the ADF assembly and the ADF controller card removal procedures.
April 25, 2013
•
Added 176—Controller board cooling fan failure error code.
•
Added Controller board cooling fan service check.
•
Changed Miscellaneous cooling fan service check to Fuser cooling fan service check.
•
Added Scanner tests to the Diagnostic menu subgroup.
•
Updated ADF separator roll removal procedure.
•
Updated Japan power cord part number.
•
Deleted part numbers 40X8399 and 40X8401.
•
Deleted duplicate and inapplicable entries in Miscellaneous parts catalog assembly.
•
The following Option‑related topics were added:
Staple finisher option removals
–
Sensor (throat media present) removal
–
Stapler/offset stacker option latch removal
–
Stapler/offset stacker tray spring removal
–
Stapler/offset stacker tray link assembly removal
–
Sensor (stapler/stacker rear door interlock) removal
–
Sensor (paddle motor HP) removal
–
Sensor (right tamper motor HP) removal
Preface
43
7463