Usb Port [X] Disabled [56] - Lexmark MX71x Service Manual

4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.

USB port [x] disabled [56]

From the printer control panel, touch Continue to clear the message.
Notes:
•
The printer discards any data received through the USB port.
• Make sure the USB Buffer menu is not set to Disabled.
Weblink server not set up. Contact system administrator.
From the printer control panel, touch Continue to clear the message.
Note: If the message appears again, then contact your system support person.
User attendance messages
User attendance messages (0‑99.99)
Error Description
code
10.xx Too many vinyl labels printed successively.
30.xx Toner cartridge missing
31.21 Toner Level Sensing reading out of range
31.22 Excessive toner sensing line noise
31.23 Abrupt change detected in toner sensing reading
31.25 Toner level sensing calibration capacitor reading too low
31.40 Toner cartridge smart chip error
31.41 Toner cartridge I2C packet timeout
31.42 Toner cartridge I2C packet has been sent but code timed-out on
receiving the data (callback)
31.43 Toner cartridge security error in the send challenge sequence
Diagnostic information
237
Action
Reduce the vinyl labels printed. Print less than
50 vinyl labels in a row, or print at least one
vinyl label per six plain paper pages.
Make sure all cartridges are installed properly.
Go to "Toner level sensing error service check"
on page 242.
Go to "Toner level sensing error service check"
on page 242.
Go to "Toner level sensing error service check"
on page 242.
Go to "Toner level sensing error service check"
on page 242.
Go to "Toner cartridge smart chip error service
check" on page 242.
Go to "Toner cartridge smart chip error service
check" on page 242.
Go to "Toner cartridge smart chip error service
check" on page 242.
Go to "Toner cartridge smart chip error service
check" on page 242.
7463