Printed Page Count - Lexmark MX71x Service Manual

3
Do one of the following:
•
Depending on the printer model, press OK or touch
•
Press X to return to the Printer setup menu.

Printed Page Count

This setting gauges the amount of usage on the printer. The value of the Printed Page Count setting equals the value
of the Picked Sides meter. After all print tests are completed, the value resets to zero.
Enter the Diagnostics menu, and then navigate to:
PRINTER SETUP > Printed Page Count
Note: The value of the setting cannot be changed manually.
Permanent Page Count (Perm page count)
This setting indicates the number of pages that are printed. After all print tests are completed, the value resets to zero.
Enter the Diagnostics menu, and then navigate to:
PRINTER SETUP > Perm Page Count
Note: The Permanent Page Count value cannot be reset.
Processor ID
This setting indicates the ID of the processor on the controller board.
Enter the Diagnostics menu, and then navigate to:
PRINTER SETUP > Processor ID
Engine Setting [x]
These settings are used by the Engine code to further customize the behavior of the printer to applications. The value
of [x] is any value from 1 to 16.
Edge to Edge
When set to On, this shifts all four margins (top, bottom, left, and right) to the physical edge of the page (printable area
of a supported paper size). This feature does not work in PPDS emulation.
To change this setting:
From the Diagnostics menu, navigate to PRINTER SETUP > Edge to Edge.
Parallel Strobe Adjustment (Par 1 Strobe Adj)
This setting adjusts the factory setting for the amount of time the strobe is sampled to determine that valid data is
available on the parallel port.
to save any changes.
Service menus
350
7463