Cisco ASR 901S Series Installation Manual page 72

Connecting Network Cables
IP65 RJ45 cable
Figure 36: IP65 Compliant RJ45 Cable
Procedure
Step 1 Remove the dust cap from the copper port on the router.
Step 2
Remove the protection cap from the RJ45 cable.
Step 3 Insert the RJ45 cable connector into the Cu port connector until the connector snaps into place. See the
following figure.
Figure 37: Connecting the RJ45 Cable to Copper Port
1
2
Step 4 Connect the bulkhead of the RJ45 cable to the Cu port and turn it clockwise until it locks in place as shown
in the following figure. Ensure that there is no gap between the bulkhead and the copper port connector.
Figure 38: Locking the Bulkhead to Copper Port
1
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
62
RJ45 bulkhead
RJ45 connetor
No gap between bulkhead and Cu port
3 Copper port on router
Installing the Router
OL-29732-01