Cisco ASR 901S Series Installation Manual page 47

Installing the Router
Note
Step 5 Tighten the metal bands using the banding strap tool, following the operating instructions in the box with the
tool. Ensure the metal bands are as tight as possible.
Step 6
Position the mounting bracket onto the pole clamp bracket support bolt as shown in the following figure.
Step 7 Install eight M8 x12 screws (with M8 spring washers) into the bolt holes.
Figure 17: Fixing the Mounting Bracket onto the Pole Clamp Bracket Assembly
1
OL-29732-01
When the metal straps are tightened to the full tension, you cannot adjust the pole clamp bracket
unless the metal straps are cut or disassembled.
M8 x 12 screws
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
Mounting the Router onto a Pole
2 M8 spring washers
37