Customer-Supplied Materials and Tools
The tool in the Strap Tool Kit is manufactured and supported by BAND-IT. For more information about
Note
the tool, see www.band-it-idex.com.
Figure 12: Strap Tool Kit Contents
1
Customer-Supplied Materials and Tools
You must supply some or all of these items to mount the router onto a pole or wall. The items you supply
depends on the installation procedure that you use.
Item
13-mm box-end wrench or socket set
Drill and drill bit
Phillips screwdriver, or other screwdriver for
cross-recessed screws
Crimping tool or pliers
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
30
Strap tool
2
Strap tool documentation (not shown)
Required for These Procedures
•
Mounting the Router onto a Pole, on page 34
•
Mounting the Router onto a Wall, on page 41
Mounting the Router onto a Wall, on page 41
Grounding the Router, on page 45
Grounding the Router, on page 45
Installing the Router
OL-29732-01