Cisco ASR 901S Series Installation Manual page 52

Mounting the Router onto a Wall
• Electric drill and standard screwdriver
• #6-AWG ground wire
• Shielded outdoor-rated Ethernet (CAT5e or better) cable
• 13-mm box-end wrench or socket set
Procedure
Step 1 Use the wall mount bracket as a template to mark four screw hole locations on your mounting surface. See
the following figure for the wall mount screw hole locations. You can optionally use the individual mounting
holes or the mounting slots.
Caution
Figure 21: Wall Mount Bracket for Wall-Mounting
Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide
42
The wall-mount surface must be able to support 21.82 lbs. (9.9 kgs [assembled FA chassis with
top cover including two SFPs, antenna, and power supply unit, and mounting bracket with attaching
screws]) or 24.47 lbs. (11.1 kgs [assembled FA chassis with top cover including two SFPs, antenna,
and power supply unit, and mounting bracket with attaching screws]) static weight.
Installing the Router
OL-29732-01