Cisco ASR 901S Series Installation Manual page 57

Hide thumbs Also See for ASR 901S Series:

Table of Contents

Installing the Router

Procedure

Step 1

In the accessory kit, locate the two-hole lug, 2 pan-head Phillips head screws used to attach the lug to the

router, and the 6-AWG ground wire.

Step 2

Set the parts aside.

Step 3

If your ground wire is insulated, use a wire-stripping tool to strip the ground wire to 0.5 inch ± 0.02 inch (12.7

mm ±0.5 mm) for the ring terminal (see the following figure).

Figure 25: Stripping a Ground Wire

Step 4

Slide the open end of the ground lug over the exposed area of the ground wire.

Step 5

Using a crimping tool (as specified by the ground lug manufacturer), crimp the ground lug to the ground wire

(as shown in the following figure).

Figure 26: Crimping a Ground Lug onto the Ground Wire

Step 6

Use a Phillips head screwdriver to attach the ground lug and wire assembly with the two screws from the

accessory kit.

Step 7

Connect the other end of the ground wire to a suitable grounding point at your site.

Step 8

Repeat steps 3 to 7 to attach the cable to the ground lug on the left side of the router.

OL-29732-01

Cisco ASR 901S Series Aggregation Services Router Hardware Installation Guide

Grounding the Router

Table of Contents

Troubleshooting