Pressure Regulator Removal; Side Trim And Side Panel Removal (Right Side Shown) - Viking DSCD130 Service Manual

Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Pressure Regulator Removal

Condition Requirements:
Main Top Removed
Gas Supply Disconnected
Gas leak hazard. To avoid risk of personal injury
or death, leak testing of the appliance must
be conducted according to the manufacturer's
instructions. Before placing appliance in operation,
always check for gas leaks with soapy water solution.
DO NOT USE AN OPEN FLAME TO CHECK FOR
GAS LEAKS.
1. Remove screw that secures manifold assembly to
range.
2. Remove screw and cover from range.
3. Remove pressure regulator from manifold.
4. Reverse procedure for installation.
Note: Use approved sealant when installing pressure
regulator.
5. Perform gas leak test.
32
Side Trim and Side Panel Removal
(Right side shown)
Condition Requirements:
Control Panel Assembly Removed
Door Assembly Removed
Island Trim Removed
1. Remove screws and lift kick plate from keyhole
screws.
2. Remove screws and side trim from range.
3. Remove keyhole screw from front of range.
4. Remove screw from back of range.
5. Remove screws, main top support, and side panel
from range.
6. Reverse procedure for installation.
©2010 Viking Preferred Service