Electrical & Gas Requirements; Electrical Requirements; Gas Connection; Manual Shut-Off Valve - Viking DSCD130 Service Manual

This range features a self-cleaning cycle. During
this cycle, the oven reaches elevated temperatures
in order to burn off soil and deposits. A powder
ash residue is left in the bottom of the oven after
completion of the self-clean cycle.
NOTE: DO NOT use commercial oven cleaners
inside the oven. Use of these cleaners can produce
hazardous fumes or can damage the porcelain
fi nishes. DO NOT line the oven with aluminum foil or
other materials. These items can melt or burn during
a self-clean cycle, causing permanent damage to the
oven.
DO NOT touch the exterior portions of the oven after
self-cleaning cycle has begun, since some parts
become extremely hot to the touch!
During the fi rst few times the self-cleaning feature is
used, there may be some odor and smoking from the
"curing" of the binder in the high-density insulation
used in the oven. When the insulation is thoroughly
cured, this odor will disappear. During subsequent
self-cleaning cycles, you may sense an odor
characteristic of high temperatures.
KEEP THE KITCHEN WELL-VENTED DURING THE
SELF-CLEAN CYCLE.
BURN HAZARD. When self-cleaning, surfaces may
get hotter than usual, therefore, children should be
kept away.
DO NOT store items of interest to children over
the unit. Children climbing to reach items could be
seriously injured.
©2010 Viking Preferred Service
General Information
Electrical & Gas Requirements

Electrical Requirements

Check your national and local codes regarding this unit.
This range requires 3 wire or 4 wire, 240-208 VAC/60
Hz. Unit must be fused separately from any other circuit.
Electrical shock hazard. To avoid the risk of
electrical shock, personal injury or death; verify
electrical power is turned off at the breaker box and
gas supply is turned off until the range is installed
and ready to operate, installation by an authorized
installer only.

Gas Connection

The gas supply (service) line must be the same size or
greater than the inlet line of the appliance. This range
uses a / " (1.3 cm) ID NPT (Sch40) inlet. Sealant on all
1
2
pipe joints must be resistive to LP gas. Failure to do so
may result in less than optimal performance.
The range is designed specifically for natural gas or
liquid propane (LP) gas. Before beginning installation,
verify that the model is compatible with the intended gas
supply.

Manual Shut-Off Valve

This installer-supplied valve must be installed in the gas
service line before the appliance in the gas stream and
in a location where it can be reached quickly in the event
of an emergency.
Connecting Gas & Electric
Gas leak hazard. To avoid risk of personal injury
or death; leak testing of the appliance must
be conducted according to the manufacturer's
instructions. Before placing appliance in operation,
always check for gas leaks with soapy water solution.
DO NOT USE AN OPEN FLAME TO CHECK FOR
GAS LEAKS.
Connect gas and electric. Before placing appliance in
operation, always check for gas leaks. This must be
performed by your dealer, a qualified licensed plumber,
or gas service company.
9