Hinge Receiver Removal; Back Panel Removal - Viking DSCD130 Service Manual

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Hinge Receiver Removal

Condition Requirements:
Door Assembly Removed
Side Panel Removed
1. Remove screws and side trim from range.
2. Remove screws and panel from range.
3. Remove screws and hinge receiver from range.
4. Reverse procedure for installation.
©2010 Viking Preferred Service

Back Panel Removal

Condition Requirements:
Rear of Range Accessed
1. Remove screws and access door from back cover.
2. Push connectors through back panel.
3. Remove screws and rear wiring channel from range.
4. Remove screws and back panel from range.
6. Reverse procedure for installation.
Disassembly
33