Panasonic KW-WP1050E Operating Instructions Manual page 58

Wi-fi phone for skype executive travel set
Table of Contents

Advertisement

Getting Started
Initialization Setup:
Problem
Initialization Setup is not
displayed.
I cannot find the IP
address assigned to the
base unit on LAN side
after restarting the base
unit in [AP-DHCP] mode.
The Initialization Setup
still indicates hotel mode
after switching the mode
selector to home mode.
After failure to enter the
user name and the
password to a prompt
screen asking for them
for 3 times, the base unit
does not respond.
58
Solution
L Dialogue boxes may not be displayed immediately due
to the state of the LAN.
L Check that the LAN or WIRELESS indicator lights in
green. Also, check if the LAN card or wireless LAN card
is on. If not, check that the LAN is connected.
L Check that the power supply was turned on in the
following order: modem, router (if you have one), base
unit, computer. When turning off the power supply, do
so in the following order: modem, base unit, router (if
you have one), computer.
L IP address of the base unit on LAN side changes from
the default IP address (192.168.102.1), after you restart
the base unit in [AP-DHCP] mode.
L The handset shows the new IP address assigned to the
base unit on LAN side. See "View wireless network
status" on page 110.
L To make the new mode effective, restart the base unit
(page 192) after the mode selector position is changed.
L Wait for 1 minute until the base unit becomes ready and
access to http://192.168.102.1 (the base unit's default
IP address) or http://kxwpa.webpage
L One minute interval is intentional to avoid malignant
access to the base unit.
Helpline Tel. No.: U.K. 0844 844 3898

Advertisement

Table of Contents
loading

Table of Contents