Table of Contents
Advertisement
3
Select the profile you wish to modify from the pull-down menu under the Select Profile
heading, then click [Edit].
4
Configure the connection mode of the profile you select in step 3, then click [Next>].
L See "Configuring the Internet connection settings" on page 51 for instructions.
5
Confirm the settings you are about to save, then click [Save].
6
Click [Restart].
L The base unit restarts in the connection mode that is registered as HOTEL or HOME
mode in the profile you have just created. (The position of the Mode selector switch
determines the connection mode.) However, editing the AP (Bridge) mode profile
while the Mode selector is switched to "HOTEL" does not restart the base unit with
the AP (Bridge) mode profile.
Note:
L To delete a profile
1
Select the desired profile from pull-down menu, then click [Delete] in step 3.
2
Click [OK] in the confirmation dialogue box.
3
Click [Restart].
– If you delete the profile you are currently using for HOTEL or HOME mode, the
profile will be reset to the default setting (DHCP).
Helpline Tel. No.: U.K. 0844 844 3898
Base Unit Settings
141
Advertisement
Table of Contents
Troubleshooting
