Panasonic KW-WP1050E Operating Instructions Manual page 27

Indicator Indicator
type colour
WAN Green/
Amber
Amber
Red
Off
Indicator
pattern
A short
blinking in
Amber and
a long
flash in
Green
Alternate
flashing
On
Flashing
Flashing
–
Helpline Tel. No.: U.K. 0844 844 3898
Status
An Internet connection has been
established using the Temporary LAN side
network settings.
L During this time, Port Forwarding, DMZ,
Packet Filtering and Static Routing
features are disabled. To re-activate
these features, change the LAN network
settings.
The networks on the LAN and WAN sides
overlap and the connection to the WAN
side of the base unit is terminated.
L The network configuration of the LAN
needs to be temporarily changed to
avoid an overlap of the LAN and WAN
networks.
An Internet connection has not yet to be
established (No IP address obtained).
The base unit firmware may be defective
and requires a firmware update.
L See "Downloading the version-up
firmware to your computer for recovering
the base unit" (page 202).
The base unit hardware may be defective.
L Visit:
http://www.panasonic.co.uk
The Ethernet cable is not connected to the
WAN port on the rear of the base unit.
Introduction
27