Table of Contents
Advertisement
Base Unit Settings
3
Configure the settings, then click [Save].
Setting
[Transmission/
reception of
Packets with
private IP
addresses via
WAN interface]
[Stateful Packet
Inspection]
[Attack Detection] L Select whether to enable or disable the attack detection
L Check the box in the Log Output column to create a log of each action.
L If you select [Enable] and check "Log Output", the log will be output. If you select
[Disable], the log will not be output even if you check "Log Output".
4
Click [Restart].
L The base unit automatically restarts and the Top Menu is displayed.
Note:
L This feature is not available in AP (Bridge) mode.
164
Description
L Select whether to deny or allow packets to be sent or
received when the source of an incoming (from WAN) packet
and the destination of an outgoing (to WAN) packet are
private IP addresses. This feature is valid when the WAN IP
address is global. The default is set to Deny.
L Check whether output or not this log. The default is set to ON.
L Select whether to enable or disable the stateful packet
inspection feature.
L Some E-mail servers authenticate clients using identification
packets which use TCP port 113. If the E-mail feature does
not work well, select [Enable (Except Ident Packets)],
which is the default setting for this feature.
L Check whether output or not this log. The default is set to ON.
feature. The default is set to Disable.
L The following type of attacks can be detected:
– TCP Scan
– UDP Scan
– ICMP Echo
L Check whether output or not this log. The default is set to
OFF.
Helpline Tel. No.: U.K. 0844 844 3898
Advertisement
Table of Contents
Troubleshooting
