Table of Contents
Advertisement
Base Unit Settings
L IP address and Subnet Mask under the WAN heading show the current WAN side
settings of the base unit.
L IP address, Subnet mask and Starting IP address (DHCP Server) under the LAN
(settings) heading show the current LAN side settings of the base unit.
1
Enter IP address, Subnet Mask and Starting IP address (DHCP Server) under the LAN
(temporary) heading.
L See also the Help on the LAN (temporary) heading for data entry.
Setting
[IP Address]
[Subnet Mask]
[Static IP Address
(DHCP Server)]
2
Click [Apply].
L The restarting page is displayed when the entered IP address, Subnet mask and
Starting IP address (DHCP Server) are correct.
200
Description
L Enter the IP address and subnet mask corresponding to your
temporary local network.
L Set the third number (0 – 255) separated by periods different
from that of the WAN, such as "192.168.101.1"
Note:
L There are some restrictions on IP address entry. For
example, "0.0.0.0" and "255.255.255.255" are not available.
L Enter the starting IP address for the DHCP server's IP
assignment.
L Set the third number (0 – 255) separated by periods same as
that of the LAN (temporary) you set above, such as
"192.168.101.100"
Helpline Tel. No.: U.K. 0844 844 3898
Advertisement
Table of Contents
Troubleshooting
