Table of Contents
Advertisement
7
Select the desired connection mode used in the current mode (HOME or HOTEL), then
click [Next>].
When the Mode selector is set to "HOME":
L Internet connection modes vary according to the Internet service provider. Select a
connection mode referring to the Internet service provider's setup information.
L Select [DHCP], [Static] or [PPPoE] if the base unit is installed in Router mode.
L Select [AP (Bridge)] if the base unit is installed in AP (Bridge) mode.
Setting
[DHCP]
[Static]
[PPPoE]
[AP (Bridge)]
Description
L Allows the base unit to receive an IP address automatically
from a DHCP server. This connection mode is usually
required for use with cable modems. Select if you are
instructed to specify DHCP, host name and/or MTU value by
your Internet service provider. Otherwise, select [Default
settings] in step 6.
L Allows the base unit to assign a specific IP address.
L Allows the base unit to receive an IP address from a PPPoE
server. This connection mode is usually required for use with
DSL modems.
L Allows the base unit to work as an access point when you
have a router at home.
Helpline Tel. No.: U.K. 0844 844 3898
Getting Started
45
Advertisement
Table of Contents
Troubleshooting
