Awm Waveform Set - Yamaha SY99 Owner's Manual

This copy operation is identical to the operation
explained in AFM element data, Copy element
(page 135). Please refer to that section for
details.
This copy operation is possible only while inside
one of the AWM editing jobs. It is not available
from the AWM job directory.
AWM ELEMENT DATA
Summary; Select an AWM waveform and specify
the pitch at which it will sound.
Procedure:
From: AWM Element job directory (JUMP #256)
Select: job 02:WaveSet
Specify: the waveform and frequency
Waveform: Select an AWM waveform from
internal preset memory (Prel, Pre2), a wave-
form card (Card), a waveform consisting of user-
loaded samples (Intr), or the waveform produced
by the output of the AFM element (AFM).
When the cursor is located at Waveform, you
can press a function key F1-F5 to select the
waveform type. For details, refer to the following
explanations of Waveform=.
Frequency Mode (normal, fixed): When this is
set to "normal", each note of the keyboard will
play the selected waveform at a different pitch.
When this is set to "fixed", the waveform will
be played back at the pitch specified by
Number regardless of which note was played.
Frequency Fine (-64...+63): This is a fine
adjustment of the waveform pitch.
Note Number (C-2...G8): This setting will
appear only if frequency mode
"fixed". This setting determines the pitch at
which the selected waveform will be played
back. When the cursor is located at Note Num-
ber, you can press F8 (Kbd) and then press a
key to specify the note number.

2. AWM waveform set

(JUMP #257)
Note
has been set to
Pressing COPY while editing 8. AWM filter will
access the Copy Filter operation. For details,
refer to AFM element data, 8.0 Copy filter, page
150.
When the cursor is located at Waveform
can press a function key F1-F5 to select the
waveform type. Pressing F1-F3 will select Pre-
set 1, Preset 2, or Card waveforms. If the con-
tents of a waveform card have been loaded into
sample memory by the Card utility 4.Load from
wave card operation (page 264), or if you have
created waveforms from samples that were
loaded into sample memory from disk or via
MIDI sample dump, pressing F4 (Intr) will
select these waveforms. If the voice mode is
09:1AFM&1AWM
pressing F5 (AFM) will select the waveform
produced by the output of the AFM element. For
details, refer to the following explanations of
Waveform=.
Waveform = Preset 1/2: The 8 Mbytes (4
Mwords) of preset waveforms in internal ROM
are organized as follows.
VOICE EDIT MODE
JUMP #257
, you
or 10:2AFM&2AWM,
157