F4) Controller Set (Pan) - Yamaha SY99 Owner's Manual

VOICE EDIT MODE
COMMON DATA
Summary: Specify the controller device that will
regulate the depth of the cyclical panning move-
ment (Pan LFO), and the controller that will
directly adjust the pan position (Pan Bias).
Procedure:
From: Voice Common job directory (JUMP #201)
Select: job 12:Ctrllr
Press: F4 (Pan)
Specify: the controller and depth for each
parameter
Pan LFO Depth (0...127): This determines the
range over which the specified controller will
regulate the depth of the Pan LFO. When this is
set to 127, the selected controller will regulate
LFO panning over the full range from no LFO
panning to maximum LFO panning. When this is
set to 0, the selected controller will have no ef-
fect on LFO panning.
Pan Bias Depth (0...127): This determines the
range over which the specified controller will
affect pan position.
MIDI Ctrl No. & Device (0...120, After Touch):
These settings determine which controllers will
regulate the depth of LFO panning and Pan Bias.
COMMON DATA
Summary: Specify controller devices, that will regu-
late the volume, the EG bias and the Cutoff Fre-
quency of the filters in each element of the voice.
Procedure:
From: Voice Common job
directory
Select: job 12:Ctrllr
Press: F5 (Other)
Specify: the controller and depth for each
parameter
130

12. (F4) Controller set (Pan)

(JUMP #227)
12. (F5) Controller set (Other)
(JUMP #201)
(JUMP #228)
To make controller settings for Pitch Bend,
Aftertouch, Modulation, or Other, press F1,F2,
F3, or F5. Refer to sections 12. (Fl), 12. (F2),
12. (F3), or 12. (F5).
MIDI Ctrl No. & Device: For details refer to 12.
(F3) Controller set (Modulation).
Remarks: Since the MODULATION 2 wheel is
detented at the center position, it is especially
useful for controlling pan. Since the MODULATION
2 wheel is assignable, to use it you must select
the MIDI Ctrl No. to which it has been assigned.
Check the Utility mode System Utility
3. Controllers (JUMP #803) settings to see the
MIDI Control Number to which the assignable
wheel has been set. For example if the
assignable wheel has been set to its initial set-
ting of MIDI Control Number 13, you would
select "013:Non-assigned no." for the Pan Bias
control number in order to use WHEEL 2 to con-
trol panning.
Note: When a voice is used in Multi Play mode,
these Pan Control settings will be effective only
if the Static Pan is set to Voice. Refer to Multi
Edit 5. Voice static pan (JUMP #408, #409).
VolLowLimit (Volume Low Limit 0...127): This
determines the lowest volume that can be set by
the specified controller. For example when this
is set to 80, the controller will reduce the volume
JUMP #227
JUMP #228