Voice Name - Yamaha SY99 Owner's Manual

no lower than 80. When this is set to 0, the con-
troller can reduce the volume to silence. When
this is set to 127, the controller will have no
effect on the volume. In addition to the controller
specified here, the volume can always be con-
trolled over its full range by an optional foot con-
troller connected to the rear panel VOLUME jack.
EG bias Depth (Eg Bias Depth 0...127): This
determines the range over which the specified
controller will control the EG bias. The result of
controlling EG Bias for an AFM element will
depend on the AModSens setting for each oper-
ator. If AModSens is set for carrier operators,
the controller assigned to EG Bias will affect the
volume of an AFM element. If AModSens is set
for modulator operators, the controller assigned
to EG Bias will affect the tone of an AFM ele-
ment. For details refer to Voice AFM Element
job 5. Sensitivity. For an AWM element, this
setting will affect the Volume.
CutoffDepth (Filter Cutoff Depth 0...127): This
determines the range over which the specified
controller will increase the cutoff frequency
specified for the filters of each element. Higher
settings will allow the controller to brighten the
tone. If the filter cutoff frequencies are already at
maximum, this will have no effect.
MIDI Ctrl No. & Device (0...120, Aftertouch):
These settings determine which controllers will
regulate each parameter.
COMMON DATA
Summary: Specify a ten-character name for the
voice being edited. In voice play mode, this voice
name will be displayed in large characters.
Procedure:
From: Voice Common job
directory
Select: job 13 :Name
Specify: the voice name
MIDI Ctrl No. & Device: For details refer to
Filter Cutoff Depth: The controller assigned to

13. Voice name

(JUMP #201)
(JUMP #229)
Remarks: Methods of entering character data are
To make controller settings for Pitch Bend,
Modulation, or Pan, press F1, F2, or F3. Refer to
sections 12. (Fl), 12. (F2). or 12. (F3).
12. (F2) Controllers set (Modulation).
CutoffDepth can be used in two ways to affect
the filter, depending on the Control Source set-
ting of each filter. Refer to Voice AFM Element
8.3 Cutoff EG or Voice AWM Element 8.3 Cutoff
EG.
Continuously control the filter cutoff: If the
Control Source of a filter is set to LFO then
the controller assigned to CutoffDepth can be
used to continuously control the cutoff fre-
quency even
while a note is sounding
Control the filter cutoff at key-on: If the Con-
trol Source of a filter is set to EG or EG-VA
then the controller assigned to CutoffDepth
will be used only at the instant the note is
played; i.e., after playing a note you can move
the controller without affecting the sound.
This can be used to give different filter cutoffs
to individual notes as you play them.
Enter a ten-character name for the voice.
To clear the currently entered name press Fl
(Clr).
To switch to upper-case characters press F2
(Uppr).
To switch to lower-case characters press F3
(Lowr).
explained in How to enter character data, on
page 30.
VOICE EDIT MODE
.
JUMP #229
1 3 1