Voice Select; Voice Directory - Yamaha SY99 Owner's Manual

VOICE PLAY MODE
Press VOICE to enter voice play mode. The following
LCD will appear:
VOICE indicates that you are in Voice Play
mode.
Voice memory (I, C, P1, P2): This indicates the
voice memory: Internal, Card, Preset 1, or Preset
2.
Bank (A-D): This indicates the voice memory
bank.
Voice number in individual bank (1-16): This
indicates the number of the voice in the bank.
Voice number in banks A-D (1-64): This indi-
cates the voice as a number between 1 (voice 1
of bank A) to 64 (voice 16 of bank D).
Transmit channel (1-16): This indicates the
transmit channel you selected in MIDI Utility
1. Setting (JUMP #807). The SY99 keyboard will
transmit data from MIDI OUT on this channel,
except when a master control setup is selected.
You can also set the transmit channel at any
time by holding SHIFT and pressing a voice select
key 1-16.
Voice name: The voice name is displayed in
large characters.
Summary: This function allows you select voices
while viewing a directory of the sixteen voices in
the currently selected voice bank.
Procedure:
From: voice play mode
Select: F8 (Dir)
Specify: one of the displayed voices
To quit: and return to the voice play display
press EXIT.
86

Voice select

To select a voice use the following procedure. The
voice will not actually change until you specify the
voice number 1-16. If you want to play a different
voice in the same bank, simply specify a different
number 1—16.
1.
2.
3.

Voice directory

(JUMP #100)
(JUMP #101)
Voice mode: This indicates the type and number
of elements used by this voice. For details refer
to Voice Edit mode. Voice Mode Select.
Effect settings: This area displays the effect
mode (OFF, SERIAL, or PARALLEL), and the
effect type for each of the two effect units. For
details refer to Voice edit, Common data
10.Effect set, page 104.
Press F1 to send bank select and program
change messages via MIDI. Refer to the follow-
ing section Send bank select and program change.
Press F6 to jump to the master control select
display. Refer to the following section Master
control select.
Press F7 to view the controller assignments for
the currently selected voice. Refer to the follow-
ing section Controller view.
Press F8 to view the voice directory. Refer to the
following section Voice directory.
Select the voice memory: INTERNAL, CARD (only
if a card is inserted into the DATA slot), PRESET
1, or PRESET 2. The selected LED will blink.
Select a bank A, B, C, or D. The selected LED
will blink.
Select a voice 1-16. The selected LED will light,
and the LCD display will show the newly
selected voice name.
The first seven characters of each ten-character
voice name will be displayed. When you select a
JUMP #100
JUMP #101