Cut Song - Yamaha SY99 Owner's Manual

SONG EDIT JOBS 1
Summary: This operation allows you to cut a song
in two, creating two shorter songs from one long
song.
Procedure:
From: song edit job directory 1 ( JUMP #600)
Select: 02:Cut Song
Specify: the song to be cut, the measure at
which it is to be cut, and the song
number to which the cut portion is to
be copied.
To execute: press ENTER.
To quit: without executing, press EXIT.
Source (1...10): Specify the song to be cut.
Measure (1...999): Specify the measure at
which the song in
and all measures following it will be cut from the
source song and copied to the destination song
location.
Destination (1...10): Specify the song number to
which the cut portion is to be moved.
SONG EDIT JOBS 1
Summary: This operation allows you to make a
copy of a song.
Procedure:
From: song edit job directory 1 (JUMP #600)
Select: 03:Copy Song
Specify: the song to be copied, and the song
number to which it is to be copied.
To execute: press ENTER.
To quit: without executing, press EXIT.

2. Cut song

(JUMP #602)
is to be cut. This measure
3. Copy song
(JUMP #603)
Remarks: The cut song operation cuts the specified
measure and all following measures from the
source song and moves them to the destination
song. The tempo, transmit channels, next song,
next mode, and song name for the destination
song will be the same as those set for the
source song.
If the destination song is already occupied by
song data, this data will be erased by the cut
operation. Before executing the cut song opera-
tion, always check to be certain that the desti-
nation song does not contain data you wish to
keep.
Errors: An attempt to cut a song will result in an
error under any of the following conditions:
When there is not sufficient sequencer
memory to perform the cut operation.
When the same song is specified as both the
source and destination.
When the song cannot be cut at the specified
measure. The measure specification is sub-
ject to the following limitations:
not be located after the end of the song data.
It should not be located within a pattern;
that is, the specified measure should always
be the first measure of a pattern.
not be located within a loop (i.e., between
repeat marks) in the pattern chain.
Source (1...10): Specify the song to be copied.
Destination (1...10): Specify the song number to
which the song in
SONG MODE
JUMP #602
It should
It should
JUMP #603
is to be copied.
2 1 5