F1) Awm Pitch Eg (Data) - Yamaha SY99 Owner's Manual

VOICE EDIT MODE
AWM ELEMENT DATA
Summary: The pitch change over time created by
the pitch EG can be affected by key-on velocity
and the speed of pitch change can be adjusted
across the keyboard. To set the shape of the
pitch EG, see 7. (F2) AWM pitch EG (EG).
Procedure:
From: AWM Element job directory (JUMP #256)
Select: job 07:PitchEG and press
F1 (Data)
Specify: pitch EG scaling, velocity, and range
Rate Scaling (-7...+7): Pitch EG Rate Scaling
determines how pitch EG rates will change
according to the note played. When this is set to
+1...+7, the pitch EG will be faster for higher
notes. When this is set to -1...-7, the pitch EG
will be slower for higher notes. When this is set
to 0, the pitch EG will be the same rate for all
notes.
AWM ELEMENT DATA
Summary: The pitch EG creates a fixed shape of
pitch change over time for each note. To adjust
speed of pitch change across the keyboard, see

7. (F1) AWM pitch EG (Data).

Procedure:
From: AWM Element job directory (JUMP #256)
Select: job 07:PitchEG and press
F2 (EG)
Specify: pitch EG parameters
168
7. (F1) AWM pitch EG (Data)
(JUMP #262)
7. (F2) AWM pitch EG (EG settings)
(JUMP #263)
Velocity Sw (off, on): When this is on, strongly
played notes will change in pitch more than
softly played notes.
Range (1/2 oct, 1 oct, 2 oct): This determines
the maximum range of the AWM pitch EG, from
1/2 octave to 2 octaves. (Note that the 8 octave
range of the AFM pitch EG is not available for
the AWM pitch EG.)
Rate Scaling: This setting determines how Pitch
EG Rates (the speed of pitch change) will be
affected by the key number of each note. The
following diagram shows the result when Pitch
EG Rate Scaling is set to +7. Notice that high
notes have a shorter pitch EG (faster EG rates)
than lower notes.
Velocity Sw (velocity switch): When this is on,
strongly played notes will change in pitch more
than softly played notes.
This indicates the time length shown by the
graphic display. To change this, hold SHIFT and
press F1-F6 (x1, x2, x5, x10, x20, x50). The
exact length of time will depend on the range.
When the pitch EG range is 1 octave, the
graphic display will cover approximately 0.5 Sec-
onds at "x1 and approximately 5 seconds at
"x50".
JUMP #262
JUMP #263