Yamaha SY99 Owner's Manual page 262

Disk Utility job directory
01:Disk Status: This allows you to check the num-
ber of disk files of each type and the remaining
free area on the disk.
02:Load From Disk: Synthesizer, sequencer, or card
data can be loaded from disk.
03:Save To Disk: Synthesizer, sequencer, or card
data can be saved to disk.
04:Format Disk: Before a newly purchased disk can
be used it must be formatted.
05:Backup Disk: Use this operation to make backup
disks for important data.
06:Rename File: An already existing disk file can be
given a different name.
07:Delete Pile: An unwanted file can be deleted
from disk.
08:Disk Save Type: This setting allows you to write
disk files in SY77 "All Data", or "Synthesizer
All" "Sequencer All" format.
Sample Utility job directory
01:Sample Dir: This allows the display, copying, and
deleting of sample data.
02:Sample Dump: Output samples and waveforms
from the SY99 by MIDI sample dump; also, out-
put sample dump requests.
03:Load From Disk: Load sample data from disk.
04:Save To Disk: Save sample data to disk.
05:Initialize Sample: Initialize the SY99's sample
memory.
MIDI Data Recorder utility
01:Output: This operation transmits MIDI bulk data
from SY99 MDR memory to an external device.
02:Input: This operation receives MIDI bulk data
from an external device into SY99 MDR
memory.
03:Load From Disk: This operation loads a file of
MIDI bulk data from disk into the SY99 MDR
memory.
04:Save To Disk: This operation saves MIDI bulk
data from SY99 MDR memory to a disk file.
05:Initialize MDR: This operation initializes the
SY99 MDR memory.
Master Control
01:controller Select: Select one MIDI master con-
trol setups, and edit setup parameters.
02:Transmit Filter: Specify which types of data will
be transmitted on which channels when the
SY99 is in master control mode.
UTILITY MODE
251