Effect Set - Yamaha SY99 Owner's Manual

MULTI EDIT MODE
Summary: Specify how the effect units are con-
nected, how the sound from each voice of the
multi is sent to the effect units, parameters for
each effect unit, and how the effect parameters
are controlled in realtime.
Procedure:
From: multi job directory
Select: job 07:Effect Set
Select: the effect parameters you wish to edit
Move the cursor in this area and press ENTER to
select a job.
01: Effect Mode Select: Specify how the two
effect units are connected, the effect type,
and volume balance. This is exactly the
same as for voice editing. Refer to Common
Data job 10.1 Effect Mode Select, page 106.
02: Effect Send: Specify how the sound of each
voice of the multi will be sent to the effect
units. Refer to the following section 7.2
Effect Send.
192

7. Effect set

(JUMP #400)
(JUMP #412)
Note: Multi effect settings differ from voice effect
03: Effect 1 Parameter: Make settings for effect
unit 1. This is exactly the same as for voice
editing. Refer to Common Data job 10.3
Effect 1 Parameter, page 108.
04: Effect 2 Parameter: Make settings for effect
unit 2. These parameters are exactly the
same as for Effect 1. Refer to Common Data
job 10.3 Effect 1 Parameter, page 108.
05: Effect Control: Specify how effect param-
eters will be affected by control change mes-
sages. This is exactly the same as for voice
editing. Refer to Common Data job 10.5
Effect Control, page 123.
Pressing F1-F5 will select the corresponding job.
settings only in job 2.Effect Send. A normal voice
allows you to specify the effect send level for
each of the one, two, or four elements. A drum
voice allows you to specify the effect send level
for each of the 76 keys. However in multi mode,
you can either specify a send level for each voice,
or specify that the voice's own effect send set-
tings be used.
JUMP #412