Panasonic Panafax UF-6200 Operating Instructions Manual page 38

Customizing Your Machine
Fax Parameter Table
No. Parameter
34 ENERGY SAVER
35 DAYLIGHT TIME
36 RING PATTERN
37 RCV TO MEMORY
38 ACCESS CODE
39 PIN CODE ACCESS
42 CONF. FILE SAVE
43 PASSWORD-XMT
44 PASSWORD-RCV
46 SELECT RCV
47 REMOTE RCV
48 TELEPHONE LINE
49 PSTN ACCESS CODE
38
Setting
Number
1
MODE
2
3
1
2
3
1
(DRD)
2
1
2
3
1
2
1
2
1
2
1
2
1
2
1
2
Setting
OFF To reduce the power consumption in standby, select either
Energy-Saver or Sleep mode and specify the Delay Time
ENERGY-
(1 to 120 minutes) for the machine to enter into the
SAVER
selected mode.
SLEEP
The Delay Timer setting is only available in the Energy-
Saver or Sleep Modes.
OFF
ENERGY-SAVER: Saves energy by consuming less
SLEEP
OFF Set the Daylight Time according to your local regulation.
OFF : Daylight time is not applied.
MAR 2nd
MAR 2nd : From 2:00 AM on the 2nd Sunday in March to
APR 1st
2:00 AM on the 1st Sunday in November.
APR 1st : From 2:00 AM on the 1st Sunday in April to
2:00 AM on the Last Sunday in October.
INVALID Selecting whether or not the machine is available for "DRD
Service". If this parameter is set to "VALID", your machine
VALID
detects the specified ring pattern only when receiving a
document automatically.
(----) Enter a 4-digit password used to print out the received
document in memory by using F8-5 (RCV TO MEMORY).
When F8-5 is set to ON, this parameter will not be shown
on the LCD display. (See page 96)
(----) Enter a 4-digit Access Code to secure the machine from
unauthorized use. (See page 94)
NONE Selecting the access method (Prefix or Suffix) to dial a
number with PIN Code. (See page 106)
SUFFIX
PREFIX
INVALID Selecting whether the machine saves the confidential
polled file even after the file is polled once.
VALID
OFF Setting a 4-digit XMT-Password and selecting whether the
machine performs and checks the XMT-Password of the
ON
receiving station when transmitting. (See page 111)
OFF Setting a 4-digit RCV-Password and selecting whether the
machine performs and checks the RCV-Password of the
ON
transmitting station when receiving. (See page 112)
INVALID Selecting whether the machine performs selective
reception. (See page 109)
VALID
INVALID Selecting whether or not the machine accepts remote
reception command. (See page 67)
VALID
PSTN Selecting the type of line connected.
PBX
(----) Setting PSTN Access Code. (Up to 4 digits)
Comments
: The unit will remain in standby mode
and consume more energy than when
in Energy-Saver or Sleep modes.
power than when in standby mode by
turning off the fuser unit after the
specified time.
: This is the lowest power state that the
machine enters after the specified time
without actually turning off.