Panasonic Panafax UF-6200 Operating Instructions Manual page 139

Facsimile transceiver
Hide thumbs Also See for Panafax UF-6200:
Table of Contents

Advertisement

Mode
TAM Interface Trouble
Cannot utilize the
in Unattended TAM I/F
remote turn-on feature
Mode (OUT Mode)
of the telephone
answering machine
(TAM). The fax
machine always
answers after the 8th
ring.
Fax machine will not
start up when the
telephone answering
machine is set to give
only an outgoing
message (OGM).
A beep...beep sound is
recorded on the
telephone answering
machine.
Fax machine starts up
in the middle of the
outgoing message
even though the caller
wants to leave a voice
message.
Cannot record any
incoming message
(ICM). The fax machine
always starts up at the
end of the OGM and
before the tape
advances to the end of
last ICM. (Your TAM
only uses a single
cassette tape to give
OGM and record ICM.)
Cannot receive from a
machine that does not
send CNG signal (a
short beep tone every
3 seconds) after
dialing.
Cannot retrieve
message from the
answering machine
remotely, the fax
machine always starts
up after the command
code is entered.
Cannot receive a fax
message, but can
record voice message.
Symptom
This feature is not compatible. The fax machine is designed to
answer after 8 rings if the TAM does not answer.
TAM that gives outgoing announcement only is not
compatible. The fax machine will work with a TAM that will
record Incoming message (ICM).
Speak a little slower between each word while recording an
outgoing message (OGM).
Make sure the outgoing message (OGM) does not have a
silent pause longer than 5 seconds.
Set Fax Parameter No. 20 (SILENT DETECTION) to
"INVALID".And, instruct the calling party to press
their touch-tone phone during the OGM to start up your fax
machine remotely.
Set Fax Parameter No. 20 (SILENT DETECTION) to
"VALID".Or, Instruct the calling party to press
their touch-tone phone during the OGM to start up your fax
machine remotely.
Set Fax Parameter No. 20 (SILENT DETECTION) to
"INVALID".
Check your outgoing message, if it is too long, the calling fax
machine may have timed out. Try shortening your outgoing
message to less than 15 seconds, or ask the calling party to
program your telephone number in their fax machine with 3
pauses and a "#" at the end. (
PAUSE #)
Troubleshooting
Cause / Action
twice on
Ex:
5551212 PAUSE PAUSE
Continued on the next page...
page
--
--
--
--
37
twice on
37
37
--
139

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents