Panasonic Panafax UF-6200 Operating Instructions Manual page 40

Customizing Your Machine
Fax Parameter Table
No. Parameter
125 CONFIRM STATIONS
133
135 JUNK FAX FILTER
136 RESTRICT D. DIAL
40
Setting
Number
1
2
JOB BUILD 1
2
01. JUNK FAX FILTER
1
2
02. RCV WITHOUT ID
1
2
03. RECEIVED ID PRINT When set to "VALID", the sender's numeric ID and
1
2
04. ID NO. REGIST.
(NO. 01-30)
1
2
Setting
INVALID Set whether to confirm the destinations.
When set to Valid the document cannot be sent unless the
VALID
destination is confirmed.
This function also operates when the addresses are
specified with Group Dialing or Program Dialing function.
If an address has been altered (added or removed) when
confirming addresses, the address confirmation message
will appears again when transmitting the documents
(pressing the start key).
OFF Selecting whether the machine performs Job Build when
the total number of documents exceeds the maximum
ON
capacity of the ADF, or when scanning the documents
manually one at a time. If you place the documents on the
ADF within 5 seconds after the ADF scan, the ADF scan
will continue for the current scan. (Maximum number of
scanning sheets is 255 pages for one job.)
The Quick Memory Transmission feature (Fax Parameter
No. 82) is not available when the Job Build is set to
"2:ON".
Up to 250 pages can be stored. When the number of
pages exceeds 255, the memory overfull message will be
displayed. Select "Yes" to start transmitting, or "No" to
cancel.
If no action is taken within 5 seconds, the machine will
start transmitting the stored originals.
Function to prevent direct mail FAX and unnecessary FAX
messages.
When set to "VALID", the machine will not receive the
faxes from the senders whose numeric ID has been
INVALID
registered as a junk fax number. The denied number IDs
VALID
can be registered in "04.ID NO. REGIST.".
When set to "VALID", the machine will receive faxes from
senders without numeric ID registered.
INVALID
(This setting is available only when "01. JUNK FAX
VALID
FILTER" is set to "VALID".)
received time are printed at the bottom of the received
INVALID
faxes. If the sender's numeric ID is not registered, only the
VALID
received time is printed. (This setting is available only
when "01. JUNK FAX FILTER" is set to "VALID".)
Register fax numbers as junk fax number.
Up to 30 fax numbers can be registered for junk fax
number. (Including numerals "0-9", blank space, and +
symbol.) (When comparing the sender's numeric ID to the
registered junk fax numbers, blank spaces between
numbers are ignored.)
INVALID Enable or disable the Restrict Direct Dial function.
When set to "VALID", manual input destination Tel No. and
VALID
"Redial" button are not accepted.
Comments