Table of Contents
Advertisement
13.2 System/Meter Settings
Menu Item
Memory Changes
(con't...)
Delete Stored Print Job
Initialize Memory/Disk
• If the distributed memory capacity cannot be maintained and memory becomes insufficient when
the port status is at Enable, the following processes will be automatically executed:
A. Change and allocate the setting values of the various memories (e.g. Receive buffer).
B. If allocation in A is not possible, set the status of the Ethernet port to Disable and reallocate.
• When the interface board is installed, disable the port status of the port not in use.
• After removing the RAM module and switching on the power, the above process will be executed
even if the memory becomes insufficient compared with the previous memory setting.
194
• PostScript Memory
Sets the memory capacity for the use of PostScript. The printing speed may be
increased when the memory capacity is increased.
Available memory capacity: 4.50-32.00 MB in increments of 0.25 MB (4.5 MB*).
Delete stored print jobs listed according to the types of print jobs:
• Secured Print
• Sample Print
Executes the initialization of NV memory and hard disk. It can also execute
system reset.
• Initialize Memory
Executes initialization of NV memory. NV memory is the nonvolatile
memory that maintains the printer setting contents even after the power has
been switched off.
• Initialize Print Meter
Executes initialization of Print Meter memory.
• All Hard Disks
• Hard Disk Partition 1
• Hard Disk Partition 2
• Hard Disk Partition 3
Executes initialization of the hard disk or the hard disk partition 1-3
Description
* factory setting
Advertisement
Table of Contents
