Table of Contents
Advertisement
Menu Item
Pitch
Sets the pitch of the font in character per inch.
Available options: 6.00 to 24.00 in increments of 1.00 or 0.01 (10.00*).
Form Lines
Sets the lines of text within a page.
Available options: 5-128 lines (64*).
Maximum No. of Sets Sets the number of output sets.
Available options: 1*-999 sets.
Image Enhancement
Enable or disable image enhancement. Image enhancement is to raise the resolution and to
produce smooth print of sharp edges.
Available options:
• On *
• Off
Hex Dump
Turns on/off the Hex (adecimal) Dump mode. Turning on the Hex Dump mode allows data
that is sent to the printer in plain ASCII format.
Available options:
• On
• Off *
Description
• Pitch is the horizontal spacing of a fixed-space (bitmap or scalable) font in
terms of number of characters per inch.
This characteristic is ignored when selecting a proportionately-spaced (bitmap
or scalable) font but is saved in the font select table and available when fixed
spaced font is selected.
• When there is a specific number of output from the host device, this value can
be displayed and printed out. Also, it can be changed on the setting of the
operator panel. However, number of specified output from Netware and lpd
cannot be changed to the operator panel.
• If there is instruction from the host device regarding the number of output copy,
that value will be reflected and printed.
• However, for number of output copy specified by Netware and lpd port, the
value of the control panel will not be overwritten after printing.
• Turning on the Hex Dump mode allows data that is sent to the printer to be
printed in plain ASCII format. It will not be interpreted by the emulation. Hex
Dump is used for troubleshooting.
• Hex Dump is supported in the Parallel, LPD and Netware interfaces.
11.2 PCL 6 Settings
* factory setting
155
11
Advertisement
Table of Contents
