Table of Contents
Advertisement
13.2 System/Meter Settings
Menu Item
Port Settings >
SMB
Port Settings >
NetWare
Port Settings >
LPD
190
To be set when using the SMB port.
Items:
• Port Status
Define the setting of the SMB port when the power is on.
Available options: Disable, Enable*.
The note items at the end of this tabulation of print/mode settings.
• Transport Protocol
Define the setting of the transport protocols, TCP/IP and NetBEUI.
Available option for TCP/IP: On*, Off. Available option for NetBEUI: On*, Off.
• Print Mode
Sets the print mode.
Available option: Auto*, PCL, PostScript.
• PJL Switch
Sets the PJL commands sent from the host device to valid or invalid.
Available options: Off, On*.
• TBCP Filter
Define the setting of the TBCP Filter when the optional PostScript software kit
is installed.
Available options: Disable*, Enable.
To be set when using the Netware port.
Items:
• Port Status
Define the settings of the NetWare port when the power is on.
Available options: Disable*, Enable.
The note items at the end of this tabulation of print/mode settings.
• Transport Protocol
Define the setting of the transport protocols, TCP/IP and IPX/SPX.
Available option for TCP/IP: On, Off*. Available option for IPX/SPX: On*, Off.
• Print Mode
Sets the print mode.
Available option: Auto*, PCL, PostScript.
• PJL Switch
Sets the PJL commands sent from the host device to valid or invalid.
Available options: Off, On*.
• TBCP Filter
Define the setting of the TBCP Filter when the optional PostScript software kit
is installed.
Available options: Disable*, Enable.
To be set when using the LPD port.
Items:
• Port Status
Define the settings of the LPD port when the power is on.
Available options: Disable, Enable*.
The note items at the end of this tabulation of print/mode settings.
If LPD is set to Enable when the IP Address is set to Specify Address,
the IP Address setting screen will be displayed. Enter the IP Address
using the displayed screen.
Description
* factory setting
Advertisement
Table of Contents
