Table of Contents
Advertisement
CHASSIS
4.
Insert the cam bushing, 3, into the bore of the
sector gear (Figure 38).
5.
Place the locking plate, 4, on the cam bushing
(Figure 38).
6.
From the bottom, insert the carriage bolt, 5,
through the bearing washer, cam bushing, and the
locking plate. Secure the bolt with the locknut, 6
(Figure 38).
7.
Adjust the steering gear, refer to "Steering
Backlash Adjustment" on page 2 - 5.
8.
Fasten both steering arms onto the sector gear.
Check wheel alignment and toe-in.
NOTE: On 2004 models and on new replacement
steering sector gears, make sure the angle of the
teeth are facing down.
2 - 12
Tilt Steering
Description
The tilt steering assembly is made up of the following
components (Figure 40):
1.
2.
3.
4.
5.
Figure 41
Figure 40
Universal joint.
Steering column (bushing mounted).
Detent bracket (left side).
Support bracket (right side).
Spring-loaded control handle.
6-35
400XT Series Tractor Service Manual
6-34
(1) Retaining Bolt
(2) Universal Joint
(3) Retaining Bolt
(4) Upper Steering
Shaft
(5) Spring Extension
(6) Bolts
(7) Detent Bracket
(8) Support Bracket
(9) Retaining Bolt
(10) Spacer-Yoke
(11) Column
(12) Tilt Lever
(13) Steering Bushing
Advertisement
Table of Contents
