Toro 400XT Series Service Manual page 41

9. Remove the damper cylinder located next to the
transaxle input pulley. To remove the fastener on
the end of the cylinder, insert the blade of a
screwdriver between the back side of the fastener
and the shaft. Apply a little pressure toward the
back of the fastener and pull the damper cylinder
off the shaft (Figure 124).
Figure 124
10. Slip the belt off the transaxle input pulley (Figure
125).
Figure 125
400XT Series Tractor Service Manual
HYDRO-GEAR TRANSAXLE
11. Use a floor jack under the transaxle to help lower
the transaxle from the frame of the tractor (Figure
126).
12. Remove the bolt, washer, and nut retaining the
torque strap to the transaxle, located on the left
front side (Figure 127).
MVC-070F
MVC-171X
Figure 126
Figure 127
MVC-073
MVC-072F
3 - 3