Table of Contents
Advertisement
Sector Gear Disassembly
1.
Remove the battery and battery bracket from the
tractor. Disconnect both steering tie rods from the
sector gear. Using the access hole in the
mounting bracket, remove the lock nut and
carriage bolt holding the sector in place (Figure
36).
Figure 36
2.
Remove the locking plate from the top of the
sector gear (Figure 37).
Figure 37
3.
Remove the cam bushing, 3, and the sector gear,
2, from the mounting bracket (Figure 38).
Important: Inspect the sector gear teeth and cam
bushing for wear and replace if necessary.
400XT Series Tractor Service Manual
Sector Gear Assembly
(1) Washer Bearing
(2) Sector Gear
(3) Bushing
1.
Install the bearing washer, 1, on the mounting
6-25
bracket (Figure 38).
2.
Place the sector gear, 2, on top of the bearing
washer with the teeth facing the rear of the tractor
(Figure 38).
3.
Ensure the steering wheel is centered, then center
the steering shaft with the sector gear (Figure 39).
6-26
CHASSIS
Figure 38
(4) Locking Plate
(5) Carriage Bolt
(6) Locknut
Figure 39
6-28
6-8
2 - 11
Advertisement
Table of Contents
