Toro 400XT Series Service Manual page 26

CHASSIS
5. Move the locking collar upward on the shaft until it
touches the column support mid bushing. Tighten
the collar set screw, then move the snap ring
upward on the shaft until it meets the bottom of
the locking collar (Figure 33).
5
3
Figure 34
(1) Universal Joint
(2) Lower Steering Gear
Shaft
(3) Retaining Bolts
6. Tilt steering to the rear position and place the
universal joint,1, onto the top end of the lower
steering gear shaft, 2. Install the retaining bolt, 3,
of the universal joint through the joint and steering
gear shaft.
7. Place upper steering shaft, 5, onto the upper end
of the universal joint,1. Install the retaining bolt 3,
through the upper end of the universal joint and
upper steering.
Note: Ensure that electrical wiring can not come
into contact with upper steering shaft of universal
joint in any position.
2 - 10
3
4
1
2
(4) Upper Steering
Shaft
(5) Steering Bushing
8. Install the rubber boot over the steering shaft and
console with a boot clip (Figure 35).
9. Place the steering wheel on the steering shaft and
install the lock washer and nut. Reinstall the
6-22
steering wheel cover.
Important: Ensure that all hardware is securely
fastened that the steering wheel is centered when
the wheels are straight ahead, and that the
steering operates properly.
Note: Ensure that electrical wiring can not come
into contact with upper steering shaft of universal
joint in any position.
400XT Series Tractor Service Manual
Figure 35
MVC-766