Toro 400XT Series Service Manual page 51

11. Install the idler spring to the idler pulley, located
toward the rear of the tractor (Figure 159).
Figure 159
12. Turn the electric PTO clutch housing and align the
PTO stop bracket in the slot of the clutch housing.
Install the RH bolt and lock washer in the PTO
stop bracket and tighten. Tighten the LH bolt in
the PTO stop bracket (Figure 160).
Figure 160
400XT Series Tractor Service Manual
HYDRO-GEAR TRANSAXLE
13. Reconnect the electric PTO clutch wire (Figure
161).
MVC-782F
14. Test the tractor to make sure the tractor and the
safety system is operating properly.
MVC-796F
Figure 161
MVC-797F
3 - 13