Table of Contents
Advertisement
CHASSIS
2.
Disconnect the right and left tie rod assemblies
(Figure 20).
Figure 20
3.
Loosen the locking nut on the eccentric. Position
the steering wheel spokes so they extend outward
left to right.
4.
Tighten the nut until the eccentric turns with a
small amount of friction (Figure 21).
Figure 21
2 - 6
5.
Using a punch, turn the eccentric clockwise until
zero clearance is obtained between the end of the
steering shaft gear and the steering sector (Figure
22).
MVC-099X
6.
Tighten the nut to 25 – 35 ft lb (34 – 48 Nm). DO
NOT OVERTIGHTEN.
7.
Apply some multipurpose grease to the steering
gear teeth.
8.
Connect the tie rod ends to the steering arms.
9.
Turn the wheels left and right. Recheck for zero
clearance (Figure 23).
MVC-110X
10. Reinstall the battery tray and battery.
11. Check wheel alignment and toe-in.
Figure 22
Figure 23
400XT Series Tractor Service Manual
MVC-113X
MVC-115X
Advertisement
Table of Contents
