Steering Specifications - Toro 400XT Series Service Manual

CHASSIS
7. Insert the top steering shaft, 4, onto the upper end
of the universal joint check the front wheel
alignment, wheels should be straight ahead.
Install the retaining bolt, 3, through the upper end
of the universal joint and steering shaft (Figure
41).
Note: Ensure electrical wiring can not come into
contact with upper steering shaft or universal joint
in any position.
8. Install the rubber boot over the steering shaft and
secure the boot to console with the rubber clip
(Figure 44).
Figure 44
Item
Free Play – front axle pivot pin
End Play – front wheel on spindle
Toe-In
Steering Wheel Free Play (Backlash)
Top (Fiber)
Mid (Metal)
Bottom (Metal)
2 - 14
MVC-766

Steering Specifications

Steering Shaft Bushings (standard dimensions)
9. Align the steering wheel on the steering shaft.
Secure the steering wheel with lock washer and
nut. Install steering wheel cover (Figure 45).
Specification
0 – 0.015" (0 – 0.4mm)
0 – 0.015" (0 – 0.4mm)
1/8" – ¼" (3 – 6mm)
0.5" – 1.0" (13 – 25mm)
ID 0.752 – 0.756" (19.1 – 19.2mm)
OD 1.310 – 1.320" (33.3 – 33.5mm)
ID 0.755 – 0.760" (19.2 – 19.3mm)
OD 0.988 – 1.00" (25.3 – 25.4mm)
ID 0.753 – 0.758" (19.1 – 19.2mm)
OD 1.380 – 1.385" (35.0 – 35.2mm)
400XT Series Tractor Service Manual
Figure 45
MVC-765