Rear Back Up Camera - Jeep RENEGADE 2016 User Manual

OPERATING YOUR VEHICLE

REAR BACK UP CAMERA

The Rear Back Up Camera that allows you to see an on-screen image of your vehicle's
rear surroundings when the shift lever is put into REVERSE. The image will be
displayed on the touchscreen display along with a note to "check entire surround-
ings" across the top of the screen. After five seconds this note will disappear. The
camera is located above the rear license plate.
When the vehicle is shifted out of RE-
VERSE (with camera delay turned OFF),
the rear camera mode is exited and the
navigation or audio screen appears again.
When the vehicle is shifted out of RE-
VERSE (with camera delay turned ON),
the camera image will continue to be
displayed for up to 10 seconds after
shifting out of REVERSE unless the ve-
hicle speed exceeds 8 mph (13 km/h),
Parking Camera
the vehicle is shifted into PARK or the
ignition is switched to the STOP/OFF po-
sition.
A touchscreen button to disable the camera is available when the vehicle is not in
REVERSE or if touchscreen button "X" at the top of the camera screen is pressed.
Display of the camera image after shifting out of REVERSE can be disabled via
Uconnect Settings.
When enabled, active guide lines are overlaid on the image to illustrate the width of
the vehicle and its projected backup path based on the steering wheel position.
When enabled, fixed guide lines are overlaid on the image to illustrate the width of
the vehicle.
Different colored zones indicate the distance to the rear of the vehicle.
The following table shows the approximate distances for each zone:
Zone Distance to the rear of the vehicle
Red 0 - 1 ft (0 - 30 cm)
Yellow 1 ft - 3 ft (30 cm - 1 m)
Green 3 ft or greater (1 m or greater)
NOTE:
If snow, ice, mud, or any foreign substance builds up on the camera lens, clean the
lens, rinse with water, and dry with a soft cloth. Do not cover the lens.
68